September 23, 2020 in Uncategorized
The model selection of the triangular belts are as follows: O-type, A-type, B-type, C-type, D-type, E-type, F-type seven models, from O-type to F-type tape section area gradually increase. SPZ SPA SPB SPC These four models are Triangular Belts narrow V type.
The choice of tape model is determined by the speed of the delivered power tape. There are a lot of knowledge in it.
The selected model should be compatible with the selected triangle tape, otherwise the triangle tape will appear abnormal in the pulley groove. When changing to the triangle tape, it is best to bring the old belt to the agricultural machinery department to buy it to prevent the model from being mistaken.
Before installation, if the center distance between the two shafts is adjustable, the center distance should be shortened first, and then the center distance should be adjusted as required after the tape is installed; if the center distance between the two shafts is not adjustable, a triangle belt can be used Put it into the groove of the wheel first, and then turn the other pulley to install the triangle tape, and install all the triangle tapes in the same way. It is forbidden to use tools to pry or pull on the Triangular Belts to prevent the Triangular Belts from being stretched or too tight. The correct inspection method is to apply a vertical pressure of about 2 kilograms to the middle of each tape by hand, and the amount of sinking is (20-30) mm. If it is not suitable, adjust it in time. When you need to replace the new and old triangle tapes with double or more than three triangle tapes, you must choose the specified type of triangle tape, and require the tightness of each group of triangle tapes to be consistent. It is not allowed to mix the new and the old or reduce the number of tapes. Otherwise, the old and new triangle tapes will be stressed. Uneven, even the old Triangular Belts does not work, affecting power transmission and shortening the life of the Triangular Belts.
hexagonal belts are also our products, and the model selection is similar to triangle belts. Welcome to consult and contact us.
September 16, 2020 in Uncategorized
Conventional V-belt is the most common V Belt For Sale type and has been around the longest. The Initial classical V design replaced leather belts by taking over their applications in a wide range of industries, such as agriculture, ventilation, and industrial machinery. Classical V-belts are capable of covering a load range from fractional(less than 1 HP) to 500 horsepower. They are less efficient than narrow V-belt and generally contribute to higher bearing loads. However, classical V-belts have high tolerance for poor operating conditions.
The general part number format is the cross section size and the inside length in inches ( e.g. B50 is a B section of 50 inches inside length ).
General cross sectional dimensions that are used in the US are shown below.