We all know that plastic chair injection mould test molds are generally a whole, only there is a small hole at the bottom of the test mold. How to drag the test mold out intact and undamaged is the most concerning issue. Here are some simple steps to teach you:
First, apply oil to the inside of the test mold before injection molding to facilitate the later removal of the mold; secondly, after brushing the oil, put a small piece of waste paper on the small hole of the test mold to protect the small hole of the test mold from being blocked by concrete; Finally, the air pump is connected with the test mode, so that a complete test mode can be dragged out.
If there is no air pump, it can only be pushed out or knocked out from the bottom hole with steel bars, etc., put a cloth on the edge of the trial mold or a certain platform, and then invert the plastic mold. Don’t use force when knocking the plastic mold. Too large, otherwise it will damage the test mold.
The electrical appliance mould can also use this method.